The 10-Minute Glow Routine: How to Get the Most Out of Your LED Mask
Share
Ten minutes is all it takes. But how you spend them — and the few minutes before and after — makes the difference between good results and great ones.
Step 1: Start Clean
Always cleanse before your LED session. Makeup and sunscreen on the skin surface block light from penetrating effectively.
Step 2: Apply LightBoost Serum
LED light temporarily increases skin cell permeability, allowing active ingredients to penetrate 2x deeper. The LightBoost Serum (hyaluronic acid + niacinamide + peptides) is formulated specifically for this window. Apply, wait 30 seconds, then mask on.
Step 3: Mask Up for 10 Minutes
Select your mode — red for aging, blue for acne, green for dark spots. The mask auto-shuts off. 10 minutes is the clinically effective session length.
Step 4: Seal the Glow
Your skin is primed for absorption immediately after. Apply Snail Glow Moisturizer right away to lock in moisture and maximize recovery.
Use 4–5 times per week. Most customers see initial changes in 2–4 weeks, with full results by 8 weeks.